DisplayPort v1.1/2.0 SDR/DDR Test Adapter Board Set
Product Number:
ET-DP-TPA-S..... $9,850
| |
ET-DP-TPA-S DisplayPort™ test adapter set provides a very high-bandwidth, low-noise evaluation vehicle that enables high-performance characterization of source and sink devices as well as cabling. Single data rate (SDR) DisplayPort v1.1 bandwidth requirements exceed 10.8 Gbps. This adapter test set will also support Double Data Rates (DDR) anticipated in the v2.0 specification.
|
 |
| DisplayPort SDR/DDR Plug Board shown with standard 2" GPPO-SMA cables |
|
|
The plug and receptacle test adapter boards included in this set feature ultra-low insertion and return loss with near-perfect signal integrity to assure that electrical results reflect the device under test, and not the fixture.
STANDARDS & COMPATIBILITY
- Compliant with DisplayPort v1.0/1.1 SDR and v2.0 DDR requirements
- v1.1 main link bandwidth of up to 10.8 Gbps, equivalent to a data transfer rate of 1080 Mbytes per second
- Industry standard DisplayPort plug/receptacle
|
 |
| DisplayPort SDR/DDR Receptacle Board |
|
|
FEATURES
- 10.2 Gbs performance per differential pair
- Insertion loss less than -3 dB at 17.5 GHz (exceeds DDR requirements)
- Return loss less than -20 dB at 10 GHz (exceeds DDR requirements)
- Trace differential impedance 100 +/- 5 ohms
- Calibration traces (SOLT) to zero out test fixture attributes
* Electrical tests performed on 2x trace with 2" GPPO to SMA adapter cables
|
 |
| DisplayPort Plug Calibration Board |
|
|
WHAT'S INCLUDED
- ET-DP-TPA-S Test Adapter Set* includes the following:
(1) ET-DP-TPA-P plug board
(2) ET-DP-TPA-R receptacle boards
(1) ET-DP-TPA-PC calibration board
(1) ET-DP-TPA-RC calibration board
(40) GPPO to female SMA cables, 2 inches long**
|
 |
| DisplayPort Receptacle Calibration Board |
|
|
STAND ALONE PRODUCTS & OPTIONS – Available to be purchased separately
ET-DP-TPA-P plug board
|
$1,750
|
(requires 10 cables, not included, see below)
|
|
|
| ET-DP-TPA-R receptacle board |
$1,000 |
| (requires 10 cables, not included) |
|
|
| ET-DP-TPA-PC calibration board |
$900 |
| (requires 5 cables, not included) |
|
|
| ET-DP-TPA-RC calibration board |
$1,200
|
| (requires 5 cables, not included) |
|
|
| 2" SMA to GPPO cables** |
$100 ea |
| 6" SMA to GPPO cables |
$150 ea |
| 24" SMA to GPPO cables |
$200 ea |
* Product purchased as a set will come from the same manufacturing lot and be optimally matched for calibration purposes. Product purchased individually will meet all specifications but cannot be guaranteed to be from the same manufacturing lot for optimal calibration.
** Efficere's DisplayPort product is tested and specified with 2" cables.
DisplayPort is a registered trademark of VESA.
|
|
